Screen protection

DISPLEX REAL GLASS


How to apply a protective glass with DISPLEX Easy-On® Sticker

Before you start application, please thoroughly clean the display and the housing with the microfibre cloth from grease and dust. Please also use the enclosed dust remover after cleaning the display and again before removing the lower protective foil of the glass. Kindly note: Even the smallest particle of dust can create air bubbles after application.

The video for the installation can be found here.

1. Clean the display and the casing thoroughly
Clean the display and the casing
2. Apply fixing strips on the frontside longitudinal (strip 2)
Apply fixing strips
3. Precisely align the glass based on the recesses
Align the film
4. Retain this position and attach the fixing strips
attach the fixing strips
Important for installation:
The glass is in the optimum position and well attached!
Important for installation
5. Fold up the glass
Fold up the glass
6. Pull off the backing film
Pull off the backing film
7. Fold back the glass and, from the fixing strips, begin to press on and allow it to adhere
Fold back the glass
8. Remove covering film and fixing strips (strip 2)
Remove the fixing strips
9. Clean the glass and press it onto
the entire display using the cloth... finished
 
 

Our tip: If you still have dust inclusions after application, carefully lift the glass at the relevant corner, carefully place the dust remover between the glass and display and thus remove the dust under the glass. Be careful not to lift up the glass higher than necessary and do not touch the bottom side of the glass.